新闻动态 News
快速链接Links
| Main Structure and Working Principle of paper Slitting Machine |
| 发布时间：2018/3/18 浏览：2401次 作者：www.wzsuzx.com |
| Paper cutting machine consists of frame, driving system, feeding machine and tension control device, traction components, cutting stand, winding and drain, etc. It is cut raw material points to several independent units, its working principle is fixed on the feeding of raw materials (see left-hand chart) feeding shaft end is equipped with magnetic powder tension controller to constant tension of raw material required, after A pair of rubber roller to traction of raw materials, the blade cut into article. Through the guide roller guide to A and B accept scroll winding products. Its transmission by main motor drive the tractor rubber roller and the receiving axis synchronous operation and achieve the goal of pulling away and finished goods receiving. 1, rack and drive system: frame around the panel and stays and feeding mechanical composition. Drive system is mainly used for drawing materials, winding, it is by the frequency conversion stepless speed regulating motor power through motor traction roller operation of V belt, the main rubber roller and the driven traction roller is clingy and synchronous operation traction walking raw material, through active traction roller driven circular knife axis synchronous operation and achieve better cutting requirements, through the circular knife axis winding and winding B synchronization operation, so as to achieve the purpose of receiving. 2, the receiving institutions and tension device: receiving institutions mainly include synchronous belt, synchronous round, magnetic powder clutch, and inflatable shaft parts. Main power by synchronous belt to enable synchronous wheel magnetic powder clutch input shaft running, just adjust the current of magnetic powder clutch, can change the tension in the receiving shaft size. 3, traction components: there are a pair of traction roller and traction components mainly had several hard anodized aluminum roller, a guy walking raw materials for finished goods rewinder. Its power from the motor through the V belt is passed to the traction roller which is running. 4, cutting tool post: cutting tool post have round knife cutting, flat knife cutting. Fuck handle through the trace of plane CAM can make the round knife axial moving adjustment blade mouth and pad set of shearing clearance groove. 5, waste winding and emissions: waste discharge by using the blower wind duct. 6, feeding mechanism, and automatic correction: feeding mechanism mainly include feeding shaft, support block, cylinder, base, moving around, etc. Automatic adjustment device: a beginning, rectifier guide roller, stents, deviation around mobile plate, the ball nut and screw, synchronous motor and control limit switch. |
| 上一篇：分切机安全操作流程需要注意哪些事项... 下一篇：分切机工艺的要求 |
